Mounting Assembly Installation
- Use the mounting hardware to attach Mounting Assemblies to the Roof Mounts. To begin, only install Mounting Assemblies at the two outer locations in the front row of the array. Each Mounting Assembly has an arrow on the top surface of the 360° swivel that should always point towards the Trim Cover.
- Secure and tighten each mounting assembly bolt using 14 lb-ft or 19 N-m of torque. The mounting base and swivel portion for each Mounting Assembly should be facing downroof as shown.
Note: If you need to adjust the position of the Mounting Assemblies later, you can loosen the mounting bolts and make the necessary adjustments.